17
Refuelling
Place the machine in a stable horizontal position on the ground.
Refuelling must be performed with the machine stopped and with the spark plug cap removed.
indicated in the owner’s manual of the engine.
IMPORTANT Clean any trace of leaked fuel. The warranty
does not cover damages caused by spilt fuel on the plastic
parts.
NOTE Fuel is perishable and should not remain in the tank for
more than 30 days.
Check/top-up engine oil
Check/top-up the engine oil according to the methods and
cautionary measures indicated in the owner’s manual of the
engine.
For a correct operation of the machine, regularly replace
the engine oil, according to the instructions in the owner’s
manual of the engine.
Make sure to check the oil level before using the machine again.
Occasional maintenance
Cutting blade
All operations concerning the cutting blade (disassembly, sharpening, balancing, repair,
reassembly and / or replacement) must be performed by a Mounteld Authorised Service Dealer.
Make sure damaged, misshapen or worn cutting blade are replaced, together with the securing
screws to preserve balance.
IMPORTANT Always use an original cutting blade bearing the code indicated in the “Technical Data” table.
Cleaning
Clean thoroughly following the instructions below every time it is used.
Cleaning the machine
– Always make sure the air intakes are free of debris.
– Do not use aggressive liquids to clean the chassis.
–
– Wash the machine with water after each use.
Cleaning the cutting blade assembly
–
paint.
Figure 20
A
C
A
Figure 19
To Next Page
Loading...
Need help?
General
