7. When the bath lift is not in use
i) If you wish to clean the bath lift whilst it is in the bath/tub (see section 9, “Cleaning”), we
recommend doing so when it is at its highest position in the bath/tub. This allows access
for cleaning both the bath/tub and the underside of the bath lift.
ii) If the bath lift is stored in the bath/tub, ALWAYS ensure the seat is lowered to the
bottom of the bath/tub.
NOTE:
If the RED light has appeared on the hand control preventing you from lowering
the bath lift to the bottom of the bath/tub for storage, recharge the battery
immediately (see section 2, “ Charging the battery”) and lower the bath lift to the
bottom of the bath/tub as soon as possible thereafter.
iii) Disconnect the battery and place on charge ready for your next bath (see section 2,
“Charging the battery”). Note: If not charging after each bath, ensure you leave the
battery connected to the hand control. Disconnect from the hand control only if the
bath lift is being removed from the bath/tub.
8. Removing the bath lift from the bath/tub
i) Ensure the bath lift is in its lowest position at the bottom of the bath/tub.
ii) Remove the battery from the hand control.
iii) Place the hand control on the seat and fold the side aps in.
iv) Hold the top of the backrest and as you pull the release tags on each of the rear suction
feet, tilt the bath lift forward (see g 8).
v) Continue to release the tags on the front suction feet and lift the complete bath lift out of the
bath/tub.
vi) Stand the bath lift upright, then wrap the hand control cable clockwise around both the
seat and tubes ensuring the cable coil is positioned underneath the actuator casing. Now
loop the remainder of the cable around one of the tubes (see g 9).
vii) Store the bath lift upright or lay it on its side.
NOTE:
• When lifting the bath lift, always lift close to your body.
• To avoid accidental damage to the hand control whilst carrying or storing, ensure it is
prevented from dangling freely.
10
To Next Page