Mountway Neptune - Page 3

3
Only continue if the light on the hand control is
constant or ashing green and if the battery has been
charged within the last 7-10 days.
When the seat reaches the top of the bath/tub:
• Release your nger from the UP button;
• Sit on the side ap and rotate onto the seat;
• Extend your feet out in front of you and keep your
hands above the seat;
• Press the DOWN button on the hand control;
• Attach the hand control and battery to the edge of
the bath/tub or to a tiled wall.
For convenience during bathing, you may raise or lower
the seat to any desired height by pressing the UP or
DOWN button and releasing it to stop.
When you have nished bathing:
• Retrieve the battery and hand control;
• Press the UP button until the side aps are level
with the top of the bath/tub;
• Release the UP button and move onto the side ap;
• Turn whilst lifting each leg out of the bath/tub;
• Drain the bath/tub.
5. When you are not using the bath lift:
• Disconnect the battery and place on charge;
• Store the lift at the bottom of the bath/tub.
To remove the lift from the bath/tub, place it in its
lowest position and:
• Disconnect the battery from the hand control;
• Place the hand control on the seat;
• Fold in the side aps;
• While holding the top of the backrest, pull the
suction release tags on the rear suction feet then
tilt the bath lift forward (g 4);
• Release the tags on the front suction feet and lift
the bath lift out of the bath/tub;
• Wrap the hand control cable clockwise around
the seat, positioning the cable coil under the
actuator casing;
• Loop the remainder of the cable around one of
the tubes(g 5);
• Store the bath lift upright or on its side.
Tracks
Hand control
Figure 3
Battery
Actuator casingCable coil
Figure 5
Figure 4
Top of
backrest
Suction
release tag