System Configuration: Purge enabled.
Enable/Disable the purge functionality.
System Configuration: Set point units
Select the dosing set point input format, % of total or “parts of” (parts per hundred).
System Configuration: Display units
Select the output format of set values and actual values. For MCHybrid only % can be displayed. For MCHigh
Output and MCWeight only kg/h are displayed.
when imperial units enabled only %(parts) or lb/h can be selected.
System Configuration: Imperial units
Imperial units, enable / disable. Set points and actuals displayed in lb/h or kg/h.
System Configuration: I/O module
Enable external communication, NONE, ANALOG, PROFIBUS or PROFIBUS (requires a special hardware
extension board).
Modbus TCP/IP is enabled by default.
System Configuration: Modbus Device address
If the controller is used in a Modbus network, the unique identity can be filled in here (1-231).
To Next Page
Loading...