Moxa Technologies MGate MB3280 User Manual

MGate MB3000 Modbus Gateway User Manual
12
DIN-Rail and Wall Mounting
Mounting on a DIN-rail: Attach the DIN-rail accessories and latch the unit onto the DIN-rail as shown.
The DIN-rail kit is ordered separately.
Mounting on the wall: Place two screws in the wall and slide the unit onto the
screws as shown. The head of the screws should be 5 to 7 mm in diameter, the
shaft should be 3 to 4 mm in
diameter, and the length of the screws should be at
least 10.5 mm. Make sure to leave about 2 mm of space between the head and the
wall.
Specifications
LAN
Ethernet
10/100 Mbps, RJ45, Auto MDI/MDIX
Protection
Built-in 1.5 kV magnetic isolation
Serial Interface
Interface
RS-232/422/485
No. of Ports
1 port
Connector Type
DB9 (male)
Signals
RS-232:
TxD, RxD, RTS, CTS, DTR, DSR, DCD, GND
RS-422:
Tx+, Tx-, Rx+, Rx-, GND
RS-485 (2-wire):
Data+, Data-, GND
RS-485 (4-wire):
Tx+, Tx-, Rx+, Rx-, GND
Serial Line Protection
15 kV ESD for all signals
RS-485 Data Direction
Patented ADDC™
Serial Communication Parameters
Parity
None, Even, Odd, Space, Mark
Data Bits
7, 8
Stop Bits
1, 2
Flow Control
RTS/CTS
Transmission Speed
50 bps to 921.6 Kbps
Software Features
Operation Mode
RTU Slave, RTU Master, ASCII Slave, ASCII Master
Utilities
MGate Manager
Multi-Masters and Multi-
Request
16 simultaneous TCP masters, 32 simultaneous requests for each TCP master

Moxa Technologies MGate MB3280 Specifications

General

Brand	Moxa Technologies
Model	MGate MB3280
Category	Gateway
Language	English