Housing
DIN-Rail
For many industrial applications, you will find it convenient to use the DIN-Rail
attachments, as shown below.
STEP 1: Use 2 screws per ear to attach DIN-Rail mounts to each of NPort
4511’s two ears.
⇒
STEP 2:
Insert the top of the DIN-Rail into
the top slot of the DIN-Rail mount.
STEP 3:
Push the bottom of NPort 4511 so that the
bottom of the DIN-Rail snaps into the
bottom slot of the DIN-Rail mount.
NOTE: The DIN-Rail mounting kit is an optional accessory.
To remove NPort 4511 from the DIN-Rail, simply reverse Steps 2 and 3 above
by grasping the bottom of the NPort 4511 unit with both hands, and then using
your fingers to pull down slightly on the bottom DIN-Rail mounts. This releases
the bottom of the DIN-Rail from the DIN-Rail mount.
1-7
To Next Page
Loading...
