NPort 5600-8-DT/DTL Series Using NPort Administrator
Deleting a COM Group
Follow the steps below to delete a COM Group and then auto-assign COM numbers for each port in the Group:
1. Select all serial ports in the Group you are deleting and then right-click to select COM Settings.
2. Select a COM number for this COM group and check the Auto enumerating COM number for selected
ports to use the COM number you select as the first starting COM number, and then click OK.
3. You will be able to view the serial ports that were assigned to and removed from the Group. Click Apply to
apply the settings.
4. Finally, click Yes to confirm.
To Next Page
Loading...
Need help?
General
