Setting Up Single-Host
NPort Server Pro User’s Manual 4-9
. Note: If you have several servers hooked up to your network, and it’s not clear which server
is the one you are currently adding, click on Locate in the Add Server Wizard window
shown in step 2 above. The “Ready” LED on the listed server will start blinking,
allowing you to identify it.
3. Select the COM port name that you would like the first port on the server to map to.
This will add all of NPort Server Pro’s ports (8 or 16, depending on the server model
number) to your NT/95/98 system, using consecutively numbered COM names. Click
on Next to continue.
To Next Page
Loading...
