15
EN
7. Charge the vacuum cleaner battery as described in the section “CHARGING THE BATTERY”.
CAUTION! The vacuum cleaner, power brush and main handle are equipped with electrical connector pins. Do
not damage or short-circuit them.
BATTERY CHARGING
CAUTION! Charge the battery before using the vacuum cleaner for the first time. The time required to charge
the battery is approximately 3.0 – 3.5 hours.
CAUTION! Only charge the battery with the supplied charger. While the battery is charging, the vacuum cleaner
cannot be started.
1. Connect the charger cable (17) to the charger socket (20) on the docking station (fig.6).
2. Place the correctly assembled vacuum cleaner with the main handle and the electric brush
on the docking station (fig.7). Connect the charger to the power supply network.
Fig. 6 Fig. 7
The status light (7) will flash to indicate that the battery is being charged.
3. A steady light (7) indicates that the battery has been recharged – disconnect the charger
from the mains when you plan to stop using the vacuum cleaner for a while.
4. Charge the battery after each use of the vacuum cleaner
CAUTION! Gentle heating of the charger is normal during the charging process.
To Next Page
Loading...
Need help?
General
