.
ELECTRICAL CONNECTION
Disconnect the appliance from the power supply.
Installation must be carried out by qualified personnel who know the current safety and
installation regulations.
The manufacturer declines all liability for injury to persons or animals and for damage to
property resulting from failure to observe the regulations provided in this chapter.
The power cable must be long enough to allow the hob to be removed from the worktop.
Make sure the voltage specified on the rating label located on the bottom of the appliance is
the same as that of the home.
BEFORE USE
IMPORTANT! The cooking zones will not switch on if pots are not the right size. Only use pots bearing the symbol
“INDUCTION SYSTEM” (Figure below). Place the pot on the required cooking zone before switching the hob on.
EXISTING POTS AND PANS
Use a magnet to check if the pot is suitable for the induction hob: pots and pans are unsuitable
if not magnetically detectable.
Cookware made from the following materials is not suitable: pure stainless steel, aluminium
or copper without a magnetic base, glass, wood, porcelain, ceramic, and earthenware.
Make sure pots have a smooth bottom, otherwise they could scratch the hob. Check dishes.
Never place hot pots or pans on the surface of the hob’s control panel. This could result in
damage.
22
EN
To Next Page
Loading...
