MRC Ltd
18 http://www.mrclab.com/
d) Socket
Socket, located at the two sides beside the front opening, could supply electricity
power for devices used in experiments and could be controlled by the
button.
NOTE: Please make sure the total load of sockets should be ≤ 500W.
e) Fuse protector
Fuse holders are installed on the top right of the equipment (refer to Figure 13).
Fuse of live wire is inside the female power cord connector. Socket (working
zone) fuse holder and neutral wire (power source) fuse holder is beside the
female connector . The specification of each fuse tube complies with the label
right below the fuse holder. Please refer to the label when replace the fuse tube.
f) Structure
i. External case body adopted 1.0 mm cold-rolled steel in double layer
structure with electrostatic coating and rust-proof treatment. The
structural strength and stability are enhanced.
ii. Inner wall of work area is fully made of Phenolic Compact Laminate
which provides corrosion resistance as well as attractive appearance;
work table is made of solid chemical resistant laminate which is easy to
clean and wash.
iii. Fume hood front window adopted 5 mm toughened glass.
iv. Control panel adopted soft-touch buttons and microprocessor control
system that make the operation easily to be controlled
v. The electronic control system could prevent overload of the circuit and
electric shock, stabilize the performance, protect the equipment and
extend the use life of the Fume Hood.
vi. The sockets (at working zone) adopted non-flammable PC material that is
specialized for laboratory use
To Next Page
Loading...