MRC Ltd
13 http://www.mrclab.com/
1.6. Inspection after Installation
Refer to this table and follow the instruction in 2.4.2, check the following items after
powering on the Fume Hood.
Checking Items Normal working status
Power status
Equipment could be powered on/switched off when press the
power button
Fan
Runs normally after pressing the Fan button; speed could be
adjusted by pressing the adjusting button
Front window
Front window could be moved smoothly by pressing the UP
and DOWN buttons
Fluorescent lamp Lamp lights up after pressing button
UV Lamp Lamp lights up after pressing button
Socket
Use multimeter to test voltage output after pressing the
socket button
NOTE: Please contact MRC technical department or agent for inspection or
trouble shooting when problems could not be solved. Methodology of trouble
shooting is stated in the After-sale Service Manual.
To Next Page
Loading...