MRC Ltd
12 http://www.mrclab.com/
Picture 10
1.5.9. Installation of exhaust duct
Take out the duct clamp and the exhaust duct. Put the clamp on the exhaust duct and
then connect the exhaust duct with the air exhaust outlet on top of the Fume Hood.
Afterwards, use Slotted screwdriver to fasten the duct clamp firmly. The other end of
the exhaust duct should be fixed outside the laboratory room and in the open air.
Picture 11
Gas inlet
Water inlet
Drain hose
Exhaust duct
Air exhaust outlet
Duct clamp
Slotted screwdriver
To Next Page
Loading...