Page: 3
INTRODUCTION
Thank you for purchasing MRC’s Prodigy Express
2
DCC (Digital Command Control)
System. You now own one of the most advanced, easy to use DCC systems available.
It comes as a complete system with a Command Station (base unit), power supply and
LCD Cab/Handheld with cable. The MRC Prodigy Express
2
DCC system will enhance the
enjoyment of your train layout for many years to come. Here at MRC, we pride ourselves
in giving you the most advanced, reliable and easy to use DCC train controls. With up
to 9,999 addresses available and use of up to 32 Cabs, you can expand your railroad
empire as much as you desire. From a beginner’s 4x8 layout to a massive club layout, the
Prodigy Express
2
gives you everything you want.
NOTE: Although there are Quick-start instructions on the back of the Cab/Handheld,
please read these instructions thoroughly to better understand and enjoy your Prodigy
Express
2
DCC system.
DCC BASIC BACKGROUND
A DCC system consists of a DCC Command Station that sends DCC commands to your
layout and DCC decoders installed in your locos that receive the DCC commands. Each
decoder equipped loco has its own address. Each decoder receives DCC commands but
only follows those commands matching its address. No more multiple blocks and no more
multiple power packs. With DCC, you can run dierent locos with dierent speeds and
directions all on the same track. You can also turn on/o the locomotive’s headlight and
activate sounds if your loco is equipped with a sound decoder. Please visit our website at
www.modelrectier.com for more information about other DCC products.
Please read this manual and your decoder manual carefully before installing and operating
your DCC system.
NOTE: The Prodigy Express
2
does not support NON-decoder equipped or analog locos.
NOTE: For more information on DCC or Prodigy Express
2
, visit the Customer
Service & Resources section of our web site at www.modelrectier.com or visit the
National Model Railroad Association’s website at www.nmra.org.
GETTING STARTED