Page 17
mrcool.com
Unit Installation
WARNING Before performing electrical work, read the following regulations
1. Electrical installation must be conducted by professionals in compliance with local laws,
regulations and this installation manual. Never artificially extend the length of a power cord. The
electric circuit must be equipped with a circuit breaker and air switch. Both must have sufficient
capacity.
2. Unit operating power must be within the nominal range stated in the instruction manual. Use
a specialized power circuit for the unit. Do not draw power from another power circuit.
3. The air conditioner circuit should be at least 1.5m away from any flammable surface.
4. The external power cords, the thermostat wires and thermostat must be effectively fixed.
5. The external power cords, thermostat wires, and thermostat must NOT directly contact any
hot objects. For example: they must not come into contact with chimney pipes, warm gas pipes
or other hot objects.
6. The external power cords, thermostat wires, and thermostat must NOT be squeezed. Never
pull, stretch or bend the wires.
7. The external power cords, thermostat wires, and thermostat must NOT collide with any metal
beam or edge on the ceiling, or touch any metal burrs or sharp metal edge.
8. Connect wires in accordance to the circuit diagram labeled on the unit or electric box. Screws
must be tightened. Slipped screws must be replaced by specialized flat-head screws.
9. Please use the power cables that are packaged with the appliance. DO NOT change the power
cables arbitrarily. Do not change the length and terminals of the power cables. If you want to
change the power cables, please contact MRCOOL’s local service center.
10. Wiring terminals should be connected firmly to the terminal board. Loose connection is not
safe.
11. After the electrical installation is finished, please use wire clamps to secure the power cords
and thermostat wires. Make sure the wires are not clamped too tight.
12. The wire gauge of the power cord should be sufficiently large. A damaged power cord or
other wires must be replaced by specialized wires. Wiring work must be done according to
national wiring rules and regulations.
Vacuum Lines
Electrical Connection
Electrical Regulations
To Next Page
Loading...
Need help?
General
