Page 9 mrcool.com
Pre-Installation Instructions
1. Checking Product Received
After receiving the product, please check for any damage caused by transportation. Shipping damage is the
responsibility of the carrier. Verify the model number, specifications, and accessories are correct prior to
installation. The distributor or manufacturer will not accept claims from dealers for transportation damage or
installation of incorrectly shipped units. If an incorrect unit is supplied, it must not be installed and it is to be
returned to the supplier. The manufacturer assumes no responsibility for the installation of incorrectly delivered
units.
2. Before Installation
Carefully read all instructions for the installation prior to installing product. Make sure each step or procedure is
understood and any special considerations are taken into account before starting installation. Assemble all tools,
hardware and supplies needed to complete the installation. Some items may need to be purchased separately.
NOTE: Make sure everything needed to install the product is on hand before starting.
3. Codes & Regulations
This product is designed and manufactured to comply with national codes. It is installer’s responsibilities to install
the product in accordance with such codes and/or any prevailing local codes/regulations. The manufacturer
assumes no responsibilities for equipment installed in violation of any codes or regulations.
4. Replacement Parts... (continued on following page)
2
Unit Installation
CAUTION
• Before serving or installing this equipment, the electrical power to this unit must be in the “off” position.
• More than one electrical disconnect may exist on this unit. Lock out and tag switch with a suitable
warning label. Failure to observe this warning may result in electrical shock that can cause personal
injury or death.
• Due to high system pressure and electrical shock potential, installation and service work can be
dangerous. Only trained and qualified persons are permitted to install or service this equipment.
Observe all warnings contained in this manual and labels/tags attached to the equipment.
1. The Conventional Weld Line Set Installation
Instructions can be found on page 11
OR
View complete install video by scanning this QR code
2.
No-Vac
®
Quick Connect
®
Line Set
Installation
Instructions can be found on page 12
OR
View complete install video by scanning this QR code
The Universal™ Series has 2 installation methods
MRCOOL
®
Preferred Method
To Next Page
Loading...
Need help?
General
