MS MAGIC - Troubleshooting

- 7 -
(1) Press the PREVIOUS/NEXT to switch EQ column.
(2) Press the VOL-/VOL+ button to adjust the level.
(3) Repeat pressing the NEXT button until the cursor is on the YES button,
and then press the MENU button to confirm. Or, select “No” to quit.
(4) Go to the Preset EQ menu, and select User EQ to enable the equalizer
setting.
Auto slide
show
Text
Set the time interval between the previous and the next
page in the auto slideshow mode.
Photo
Set the time interval between the previous and the next
slide in the slideshow mode.
FM Radio
Stereo Switch
Enable or disable stereo effect
FM Region
Set the frequency band for the local area
Display
Backlight Time
Set the duration of the backlight after a key press.
Brightness
Set the brightness of the screen
Backlight mode
Normal – Half darken the screen when there is no
activity within a few minutes
Power Save - Entirely darken the screen when there is
no activity within a few minutes.
Power Off
Set the continuous working time before the player is turned off automatically.
Language
Select the language for on-screen texts
System
About
Display firmware version and capacity information of the
player
Upgrade
Upgrade the firmware
Load Defaults
Restore system settings to defaults
Troubleshooting
Problem
Possible Cause
Solution
The LCD displays
nothing when the
device is started.
Battery is too low.
Charge the battery.
No sound when
playing an audio file.
The volume is too low.
Adjust the volume.
Bad audio file.
Delete or skip the file.
The player cannot be
connected to the PC.
The USB interface is not
supported by PC’s
motherboard.
Update or replace the PC’s
motherboard.
The displayed time is
changing constantly.
The bit rate of the MP3 file
is changing during
playback.
Try to use fixed bit rate to compress
the MP3 file.
The PC has error
when you plug and
unplug the player.
The player is
disconnected from the PC
abruptly while transferring
files.
Do not disconnect the player from
the PC when transferring files.