To Next Page

To Previous Page

screwdriver.

3. Remove the clip from the back housing. 4. Place the replacement clip on the back housing.

5. Install the two screws with a Phillips head #1 torque

screwdriver. Torque to 6 in-lbs (0.68 N-m).

5.1.4 Front Housing Replacement

This section will briefly describe how to replace the front housing for the ALTAIR io 4 Gas Detection Wearable.

Tools Required:

• Phillips head #1 torque screwdriver

ALTAIR io 4 38

5 Device Care US

Other manuals for MSA ALTAIR io 4

Questions and Answers:

Need help?

Do you have a question about the MSA ALTAIR io 4 and is the answer not in the manual?

General