What to do if MSA ALTAIR Single Gas Gas Detectors have a low battery alarm?
If your MSA Gas Detectors are showing a low battery alarm (horn sounds, LEDs activate), remove the device from service and contact MSA during the warranty period.
What to do if MSA ALTAIR Single Gas show low battery warning?
If your MSA Gas Detectors are showing a 'Low battery warning indicator (no alarm)', remove the device from service and contact MSA during the warranty period.
What to do if MSA Gas Detectors show EEPROM Data Error?
If your MSA Gas Detectors display 'EEPROM Data Error', first try calibrating the instrument. Then, reconfigure any custom settings you have, such as alarm setpoints or datalog settings. If the error persists, remove the device from service and contact MSA during the warranty period.
How to fix Sensor under range on MSA Gas Detectors?
If your MSA Gas Detectors indicate a 'Sensor under range' error, attempt to calibrate the instrument. If calibration doesn't fix the problem, remove it from service.
What to do if MSA ALTAIR Single Gas Gas Detectors display temperature out of range?
If the MSA Gas Detectors display shows 'Temperature out of range', remove it from service and contact MSA during the warranty period.
What to do if MSA ALTAIR Single Gas show EEPROM inoperative?
If your MSA Gas Detectors display 'EEPROM inoperative', remove the device from service and contact MSA during the warranty period.
What to do if MSA ALTAIR Single Gas show RAM inoperative?
If your MSA Gas Detectors display 'RAM inoperative', remove the device from service and contact MSA during the warranty period.
General| Sensor Type | Electrochemical |
|---|---|
| Display | LCD |
| IP Rating | IP67 |
| Gas Type | H2S, CO, O2 |
| Detection Range | H2S: 0-100 ppm |
| Alarm Type | Visual, audible, and vibrating |
| Battery Life | Up to 2 years |
| Operating Temperature | -20°C to +50°C |
| Resolution | O2: 0.1% |
| Response Time | T90 < 15 seconds |
| Operating Humidity | 15% to 95% RH (non-condensing) |
| Battery Type | Lithium |
| Certifications | UL, CSA, ATEX, IECEx |
Instructions for manually changing low and high alarm setpoints before device activation.
Step-by-step guide to activate the ALTAIR Single Gas Detector and set alarm parameters.
Explains how to check remaining operating time and battery status, including low battery warnings.
Details alarm setpoints and how the instrument indicates toxic or oxygen gas alarm conditions.
Explains how the ALTAIR detector measures oxygen concentration and its alarm triggers.
Describes how to navigate through the instrument's information pages using the TEST button.
Details the instrument's capability to record and transfer up to 25 recent events to a PC.
Procedure for performing a daily alarm test to ensure all alarm functions are active.
Instructions for performing a daily bump test to verify sensor response and instrument functionality.
Step-by-step guide to calibrate CO and H2S sensors using calibration gas.
Procedure for calibrating the oxygen sensor of the ALTAIR detector using fresh air.
Details the warranty terms, coverage, and limitations for MSA portable instruments.
Guidance on resolving issues with the ALTAIR Single Gas Detector using troubleshooting guidelines.
Provides detailed technical specifications for the ALTAIR Single Gas Detector.
Details the specifications related to event logging capabilities of the instrument.
To Next Page
