MSA DR-209M - Measurement Instruments, Tools and Appliances; Marking and Sealing; Packaging

Operating manual
Page 6
Table 1 – Description of Product’s controls
№
Name
Description
1
Button “ ”
To access the Product’s settings menu
2
Button “▲»
To increase the backlight brightness
3
Button “▼»
To decrease the backlight brightness
4
Button « ”
To exit the settings menu; change of screens
5
Button “ ”
To switch ON (OFF) power
The Product is equipped with an LCD monitor and resistive touch panel,
providing:
a. configuration of the Product (while commissioning);
b. troubleshooting (in operation and service modes);
c. screens can be changed by manual roundtrip scrolling or by choosing a num-
ber of the relevant screen;
d. display of current and service data (using the relevant operation mode).
Caution! LCD monitor with touch panel of resistive type (surface touch layer)
is intended for application only with blunt smooth instruments. Sharp instruments
(writing pen or pencil end) or harsh mechanical impact on the monitor is prohibited
to avoid damage.
1.4 MEASUREMENT INSTRUMENTS, TOOLS AND APPLIANCES
Operability control of the Product is carried out using integrated controls and
LEDs.
Consumables for TS are represented in Table 2.
1.5 MARKING AND SEALING
The nameplates, where the user can find a serial number, date of manufacturing,
weight, IP rating, input voltage and power consumption are located on the Product’s
casing.
The sealing of the Product and package is not provided.
1.6 PACKAGING
The Product is packed in a corrugated board box ensuring its transportation and
storage at the warehouse.