8
• batteries for damage or leakage
Image indicates no damage.
Stand Alone Battery Charger
The battery charger [sold seperately] is the same that
is used with the EVOLUTION
5000 TIC or is available
as accessory [see ordering information]. Please
consult your EVOLUTION
5000 TIC users manual for
battery charging instructions. The battery must be
removed from the Transmitter prior to charging.
Truck Charger
When the Transmitter is attached to the EVOLUTION
5000 TIC, the combined unit cannot be used with the
EVOLUTION
5000 Truck Charger or Truck Bracket.
The Transmitter must be completely detached from
the TIC before inserting the TIC into the Truck Charger
or Truck Bracket. The Transmitter battery cannot be
charged while inside the Transmitter.
CAUTION
Although the EVOLUTION
5000 TIC and
EVOLUTION
5000 Transmitter use the same type
of battery, each component is powered seperately.
The Transmitter battery does not provide power to
the TIC and the TIC battery does not provide power
to the Transmitter. Battery indicators are
independent for each device.
5 Maintenance and Adjustments
General Maintenance
After each use, inspect
• the Transmitter for structural, heat and / or
chemical damage.
• the mechanical hardware to ensure no
screws are loose and no O-rings or gaskets
are loose or misplaced.
• to ensure that all warning labels are intact.
• battery - see "Battery Care and Installation"
• charger and Transmitter LED´s for proper
indication that the system is operating
properly.
NOTE: Transmitter not meeting the above
inspection must be removed from service and
returned for repair.
Cleaning
After each use, clean all external surfaces by wiping
with a solution of mild detergent and warm water.
Dry with a lint-free cloth, to avoid scratching the
surfaces.
Periodically check connector terminals, video socket,
channel switch, locking latch and hinge for
contamination. Clean with a lint-free cloth.
CAUTION
Do not use solvents or paint thinners to clean the
Transmitter; otherwise, the protective case may
become degraded.
WARNING
Do not remove the Transmitter cover or electrical
casing. Only authorized personnel may service the
unit.
To Next Page
Loading...
