MSA MultiGard 5000 - Replacement Parts and Repair Ordering Information

ASK 3103-1001 Rev. 01
REPLACEMENT PARTS AND REPAIR ORDERING INFORMATION
To expedite prompt handling of your spare parts or repair orders, please specify the following information:
ORIGINAL MSA ORDER NO.:
ANALYZER AND SYSTEM SERIAL NO.:
MSA PART NO.:
COMPONENT DESCRIPTION:
MALFUNCTION DESCRIPTION (REPAIR ORDERS ONLY):
If any of the above is not available, specify the following:
ORIGINAL MSA ORDER NO.:
ANALYZER AND SYSTEM SERIAL NO.:
ANALYZER TYPE AND MODEL NO.:
COMPONENT MANUFACTURER:
MANUFACTURER’S PART NO.:
COMPONENTS DESCRIPTION:
COMPONENT PARAMETERS (FLOW, PRESSURE, VOLTAGE, FREQUENCY, RPM, ETC.)
MATERIALS OF CONSTRUCTION:
MSA DRAWING NO. OR INSTRUCTION MANUAL PAGE NO. SHOWING
COMPONENTS:
MALFUNCTION DESCRIPTION (REPAIR ORDERS ONLY):
(NOTE: SEND PHOTOGRAPHS OF THE COMPONENT OR SEND THE ACTUAL COMPONENT TO
MSA IF THERE IS ANY DOUBT ABOUT ITS IDENTIFICATION)
SEND SPARE PARTS ORDERS TO:
Mine Safety Appliances Company - Instrument Division
P.O. Box 427
Pittsburgh, PA 15230
RETURN MATERIAL FOR REPAIR TO:
Mine Safety Appliances Company - Instrument Division
1000 Cranberry Woods Drive
Cranberry Township, PA 16066
RETURN GAS CYLINDERS TO:
Mine Safety Appliances Company - Instrument Division
1000 Cranberry Woods Drive
Cranberry Township, PA 16066
Attention: Cylinder Department