MSA Ultima Series Quick Start Guide

GB
Order No.: 10083027/00
Quick Start Guide
ULTIMA/ULTIMA
®
X Series
Controller and Calibrator
The quick start guide does not replace the operating
manual. It is imperative that the operating manual file on
CD be read and observed when using the apparatus. In
particular, the safety instructions, as well as the infor-
mation for the use and operation of the apparatus, must
be carefully read and observed.
The operating manual can also be provided as a hard
copy upon request.
Fig. 1 Calibrator Fig. 2 Controller
1 Zero Button 1 Display
2 Calibrate Button 2 Numeric Buttons
3 Address Button 3 Operating Buttons
The Calibrator and Controller are hand-helds for non-intrusive
calibration of an ULTIMA/ULTIMA X Series Gas Monitor,
enabling the Monitor to be calibrated without opening the
enclosure.
They are intrinsically safe products for use in hazardous areas.
1
1
2
3
2
3

MSA Ultima Series Specifications

General

Display	LCD with backlight
Communication Ports	RS-485, Modbus RTU
Measurement Range	Depends on sensor connected
Accuracy	Depends on sensor connected
Outputs	relays
Certifications	UL