MSG Equipment MS008 - Troubleshooting Guide for MS008; Recycling of the Test Bench

English
User manual
15
7. TROUBLESHOOTING GUIDE
Below you will find the table with the possible problems and the solutions on their elimination.
Problem Causes Solutions
1. The bench doesn’t
start.
Automatic cut-out activated.
Unscrew the rear bench cover,
set the automatic cut-out into
up position.
One of the bench supply
phases (L1/L2/L3) is not active,
or neutral N
Restore the supply
2. The bench runs but
the electric motor
doesn’t start.
The variable speed drive
software error.
Contact the dealer
The bench wiring is damaged.
3. When the bench runs
the abnormal noises are
heard.
The diagnosed unit is mounted
wrong. (The drive belt over
tightened or out of alignment)
Re-mount the unit for the
diagnostics
4. When the bench runs
the belt slips (whistles).
The belt tightening is not
enough
Stop the drive and check the
tightening intensity
The wear of the belt
Replace the belt
5. During the alternator
test the contact clips
heat up much. (alligator
clips)
The contact area is small
Use a positive terminal adapter
of the alternator
8. RECYCLING
For the recycling of the bench refer to the European Directive 2202/96/EC (WEEE Directive - the
directive on waste electrical and electronic equipment).
The outdated electronic devices and electrical appliances, including the cables, hardware,
batteries and storage batteries shall be disposed separately from the house waste.
To dispose the waste products, exploit the available returning and collecting systems.
The appropriate disposal of the outdated devices helps to prevent harming to environment and
health.