MSG MS015 COM - Cleaning & Care; Major Faults and Troubleshooting Techniques

12
Soft tissues or wipe cloths should be used to clean the surface of the device with neutral
detergents. The display should be cleaned with a special ber cloth and a screen cleaning spray.
No abrasives or solvents should be used to prevent corrosion, failure or damage to the tester
Possible malfunctions and ways to x them are described in the below table:
6.2 Cleaning & Care
7. MAJOR FAULTS AND TROUBLESHOOTING TECHNIQUES
Failure symptom Potential cause Troubleshooting tips
1. The tester fails to be switched
on
1.1. Poor contact with the
diagnostic connector.
1.1. Check the connector for
secure xation
2. Tested parameters are
displayed incorrectly.
2.1. Poor contact on the probe
connectors.
2.2. Software error.
2.1. Restore the contact.
2.2. Contact the sales
representative.
3. Data is displayed partially.
3. 1. Check the continuity of
diagnostic probes.
3.2. Software error.
3.1. Replace the probes.
3.2. Contact the sales
representative.
4. The display doesn't respond
to the operator's touch.
4.1. The touch screen is
damaged.
4.1. Contact the service
department.
5. Diagnostics fails to be
launched.
5.1. Operating system
malfunction.
5.1. Contact the service
department.
User Manual - MS015 COM Tester
English