Need help?Do you have a question about the MSI 2000 and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Diode Test | Yes |
| Continuity Test | Yes |
| Data Hold | Yes |
| Power Supply | 9V battery |
| hFE Test | Yes |
| Display | LCD |
| AC Voltage Range | 200V |
| DC Current Range | 200μA to 10A |
| Safety Rating | 600V |
Manage and select aircraft profiles.
Configure and calibrate servo channels.
Configure core system parameters and calibration.
Select aircraft profiles within calibration mode.
Calibrate servo endpoints and centers.
Configure system parameters in calibration mode.
Configure settings for the first aircraft profile.
Configure settings for the second aircraft profile.
Configure settings for the third aircraft profile.
Select between Up Timer, Down Timer, or Down Stop Timer modes.
Set the number of minutes for the flight timer.
Set the number of seconds for the flight timer.
Configure and calibrate the Aileron servo.
Configure and calibrate the Elevator servo.
Configure and calibrate the Rudder servo.
Adjust reverse and down settings for Aileron servo.
Set the center position for the Aileron servo.
Configure dual rates for Aileron control.
Configure Mixer 1A settings.
Set up V-tail mixing for aircraft.
Set up Elevon mixing for flying wing aircraft.
Configure dual aileron mixing.
Access the Auto Trim setup menu.
Copy current aircraft settings to another profile.
Configure settings for buddy box operation.
Configure output channels and trim assignments.
To Next Page