CHAPTER 3 AWARD
®
BIOS SETUP
3-19
UART 2 Mode
This item allows you to select which mode for the Onboard Serial
Port 2. The settings are: Standard, HPSIR, ASKIR.
IR Function Duplex
This item allows you to select the IR half/full duplex function.
TX, RX inverting enable
This item allows you to enable the TX, RX inverting which depends
on different H/W requirement. This field is not recommended to change its
default setting for avoiding any error in your system.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset
that provides Standard, ECP, and EPP features. It has the following options:
Disable
3BCH/IRQ7 Line Printer port 0
278H/IRQ5 Line Printer port 2
378H/IRQ7 Line Printer port 1
To Next Page
Loading...
