MSI 694D PRO - Video off Method; Modem Use Irq

CHAPTER 3 AWARD
®
BIOS SETUP
3-24
Video Off Method
This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off
the vertical and horizontal synchronization
ports and write blanks to the video buffer.
Blank Screen This option only writes blanks to the video
buffer.
DPMS (default) Initial display power management signaling.
Modem Use IRQ
This determines the IRQ in which the MODEM can use.
The settings are: 3, 4, 5, 7, 9, 10, 11, NA.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the
system to enter the Soft-Off state. The settings are: Delay 4 Sec, Instant-Off.
State After Power Failure
This option will determine how the system will power on after a
power failure.
LED In Suspend
This item determines which state the Power LED will use. The
settings are Blink, Dual color, and Single color.
Blink Power LED will blink when the system enters the
suspend mode.
Dual Color Power LED will change its color when the system
enters the suspend mode.
Single Color Power LED will always remain lit.
(default)