3-21
BIOS Setup
Re-Call VGA BIOS from S3
When ACPI Standby State is set to [S3/STR], users can select the options in this
field. Selecting [Yes] allows BIOS to call VGABIOS to initialize the VGA card when
system wakes up (resumes) from S3 sleep state. The system resume time is short-
ened when you disable the function, but system will need an AGP driver to initialize
the VGA card. Therefore, if the AGP driver of the card does not support the initializa-
tion feature, the display may work abnormally or not function after resuming from S3.
Options: [Auto], [Yes], [No].
Power Management
This item is used to select the degree (or type) of power saving and is related to the
HDD Power Down item. There are three options for power management:
[Min Saving] Minimum Power Management. Suspend Mode=1 Hour
[Max Saving] Maximum Power Management. Suspend Mode=1 Min
[User Define] Allows end users to configure each mode separately.
Video Off Method
This determines the manner in which the monitor is blanked.
[V/H SYNC+Blank] This selection will cause the system to turn off the
vertical and horizontal synchronization ports and write
blanks to the video buffer.
[Blank Screen] This option only writes blanks to the video buffer.
[DPMS Support] Initial display power management signalling.
Video Off In Suspend
This option enables the monitor to be turned off during the suspend mode. Setting
options: [Yes], [No].
Suspend Type
This item allows you to select he suspend type for system power management.
Setting options: [Stop Grant], [PwrOn Suspend].
MODEM Use IRQ
This setting names the interrupt request (IRQ) line assigned to the modem (if any) on
your system. Activity of the selected IRQ always awakens the system. Setting options:
[3], [4], [5], [7], [9], [10], [11], [NA].
Suspend Mode
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off. Setting options: [Disabled], [1 Min], [2 Min], [4
Min], [8 Min], [10 Min], [20 Min], [30 Min], [40 Min], [50 Min], [60 Min].
HDD Power Down
If HDD activity is not detected for the length of time specified in this field, the hard disk
drive will be powered down while all other devices remain active. Setting options
: [Disabled] and [1] through [15] Min.
To Next Page
Loading...
