49
BIOS Setup
▶ Initiate Graphic Adapter [PEG] (optional)
Selects a graphics device as the primary boot device.
[IGD] Integrated Graphics Display.
[PEG] PCI-Express Graphics Device.
▶ Integrated Graphics [Auto] (optional)
If set to Force, BIOS will enable the integrated graphics controller.
▶ UMA Frame Buffer Size [Auto] (optional)
item will be available when Integrated Graphics is enabled.
▶ USB Conguration
Sets the onboard USB controller and device function. Press Enter to enter the sub-
menu.
▶ XHCI Hand-off [Enabled]
▶ Legacy USB Support [Enabled]
Sets Legacy USB function support.
[Auto] The system will automatically detect if any USB device is connected
and enable the legacy USB support.
[Enabled] Enable the USB support under legacy mode.
[Disabled] The USB devices will be unavailable under legacy mode.
▶ Super IO Conguration
Sets system Super I/O chip parameters including LPT and COM ports. Press Enter to
enter the sub-menu.
▶ Serial (COM) Port 0 Configuration
menu.
▶ Serial Port [Enabled]
Enables or disables serial port.
▶ Serial (COM) Port0 Settings [Auto]
Sets serial port 0. If set to Auto, BIOS will optimize the IRQ automatically or you
can set it manually.
▶ Parallel (LPT) Port Configuration
sub-menu.
▶ Parallel (LPT) Port [Enabled]
Enables or disables parallel(LPT/ LPTE) port.
▶ Parallel (LPT) Port Settings [Auto]
Sets parallel port (LPT). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.