EasyManua.ls Logo

MSI G41TM-S01 Series

MSI G41TM-S01 Series
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BIOS Setup
MS-7602
3-21
BIOS Setup
MS-7602
tRP
When the DRAM Tmng Mode sets to [Manual], the 󰘰eld s adjustable. Ths settng
controls the number of cycles for Row Address Strobe (RAS) to be allowed to pre-
charge. If nsu󰘲cent tme s allowed for the RAS to accumulate ts charge before
DRAM refresh may be ncomplete and DRAM may fal to retan data. Ths tem ap-
ples only when synchronous DRAM s nstalled n the system.
tRAS
When the DRAM Tmng Mode sets to [Manual], the 󰘰eld s adjustable. Ths settng
determnes the tme RAS takes to read from and wrte to a memory cell.
tRTP
When the DRAM Tmng Mode sets to [Manual], the 󰘰eld s adjustable. Ths settng
controls the tme nterval between a read and a precharge command.
tRFC
When the DRAM Tmng Mode sets to [Manual], the 󰘰eld s adjustable. The row cycle
tme determnes the mnmum number of clock cycles a memory row takes to com
-
plete a full cycle, from row actvaton up to the prechargng of the actve row.
tWR
When the DRAM Tmng Mode sets to [Manual], the 󰘰eld s adjustable. It spec󰘰es
the amount of delay (n clock cycles) that must elapse after the completon of a vald
wrte operaton, before an actve bank can be precharged. Ths delay s requred to
guarantee that data n the wrte bu󰘯ers can be wrtten to the memory cells before
precharge occurs.
tRRD
When the DRAM Tmng Mode sets to [Manual], the 󰘰eld s adjustable. Spec󰘰es the
actve-to-actve delay of d󰘯erent banks.
tWTR
When the DRAM Tmng Mode sets to [Manual], the 󰘰eld s adjustable. Ths tem
controls the Wrte Data In to Read Command Delay memory tmng. Ths consttutes
the mnmum number of clock cycles that must occur between the last vald wrte op
-
eraton and the next read command to the same nternal bank of the DDR devce.
FSB/DRAM Rato
Ths tem wll allow you to adjust the rato of FSB to memory.
Adjusted DRAM Frequency (MHz)
It shows the adjusted Memory frequency. Read-only.
Adjust PCI-E Frequency (MHz)
Ths 󰘰eld allows you to select the PCIE frequency (n MHz).
Auto Dsable DRAM/PCI Frequency
When set to [Enabled], the system wll remove (turn o󰘯) clocks from empty DIMM and
PCI slots to mnmze the electromagnetc nterference (EMI).
CPU Voltage (V)/ CPU GTL REF (V)/ DRAM Voltage (V)/ DRAM REF (V)/ NB Voltage
(V)/ VTT FSB Voltage (V)
These tems are used to asjust the voltage of CPU, Memory and chpset.

Related product manuals