MSI G41TM-S01 Series

3-22
BIOS Setup ▍
MS-7602
BIOS Setup ▍
MS-7602
For CPU Voltage:
The value here s the o󰘯set for you to adjust/add based on the current CPU voltage.
Please read the real-tme CPU voltage n “CPU Vcore” n the “H/W montor” page. Please
note the based CPU Voltage wll vary dependng on the d󰘯erent CPU you nstall.
For DRAM Voltage:
Accordng to the Inte CPU spec, DRAM Voltage settng 1.65V may damage the CPU
permanently. It s strongly recommended that you nstall the DRAM wth the voltage set
-
tng below 1.65V. You can read the DRAM voltage n GreenPower Center.
Spread Spectrum
When the manboard’s clock generator pulses, the extreme values (spkes) of the pulses
create EMI (Electromagnetc Interference). The Spread Spectrum functon reduces the
EMI generated by modulatng the pulses so that the spkes of the pulses are reduced to
󰘱atter curves. If you do not have any EMI problem, leave the settng at Dsabled for opt
-
mal system stablty and performance. But f you are plagued by EMI, set to Enabled for
EMI reducton. Remember to dsable Spread Spectrum f you are overclockng because
even a slght jtter can ntroduce a temporary boost n clock speed whch may just cause
your overclocked processor to lock up.
Important
If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system
stablty and performance. But f you are plagued by EMI, select the value of Spread
Spectrum for EMI reducton.
The greater the Spread Spectrum value s, the greater the EMI s reduced, and the
system wll become less stable. For the most sutable Spread Spectrum value, please
consult your local EMI regulaton.
Remember to dsable Spread Spectrum f you are overclockng because even a slght
jtter can ntroduce a temporary boost n clock speed whch may just cause your over
-
clocked processor to lock up.
▶
•
•
•