MSI H55M-E32 series - Page 39

MS-7636 Mainboard
English
En-29
MS-7636 Mainboard
English
Intel Virtualization Tech
This item is used to enable/disable the Intel Virtualization technology. For further
information please refer to Intel’s o󰘲cial website.
Intel VT-d Tech
This item is used to enable/disable the Intel Virtualization Technology for Directed
I/O (VT-d). For further information please refer to Intel’s o󰘲cial website.
Active Processor Cores
This item allows you to select the number of active processor cores.
Intel EIST
The Enhanced Intel SpeedStep technology allows you to set the performance level of
the microprocessor whether the computer is running on battery or AC power. This 󰘰eld
will appear after you installed the CPU which supports speedstep technology.
C1E Support
To enable this item to read the CPU power consumption while idle. Not all processors
support Enhanced Halt state (C1E).
Intel Turbo Boost
This item will appear when you install a CPU with Intel Turbo Boost technology. This
item is used to enable/ disable Intel Turbo Boost technology. It can scale processor
frequency higher dynamically when applications demand more performance and TDP
headroom exists. It also can deliver seamless power scalability (Dynamically scale up,
Speed-Step Down).
Adjust CPU Base Frequency (MHz)
This item allows you to set the CPU Base clock (in MHz). You may overclock the CPU
by adjusting this value. Please note the overclocking behavior is not guaranteed.
Adjust CPU Ratio
This item allows you to adjust the CPU ratio. Setting to [Startup] enables the CPU run-
ning at the fastest speed which is detected by system.
Adjusted CPU Frequency (MHz)
It shows the adjusted CPU frequency (Base clock x Ratio). Read-only.
Current iGPU Frequency
These items show the current frequencies of iGPU. Read-only.
MEMORY-Z
Press <Enter> to enter the sub-menu.
DIMM1~2 Memory SPD Information
Press <Enter> to enter the sub-menu. The sub-menu displays the informations of
installed memory.
Current DRAM Channel1~2 Timing
It shows the installed DRAM Timing. Read-only.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶