3-10
MS-7030 ATX Mainboard
Security Option
This specifies the type of BIOS password protection that is implemented. Settings are
described below:
APIC Function
This field is used to enable or disable the APIC (Advanced Programmable Interrupt
Controller). Due to compliance with PC2001 design guide, the system is able to run in
APIC mode. Enabling APIC mode will expand available IRQ resources for the system.
Settings: [Enabled], [Disabled].
MPS Table Version
This field allows you to select which MPS (Multi-Processor Specification) version to
be used for the operating system. You need to select the MPS version supported by
your operating system. To find out which version to use, consult the vendor of your
operating system. Settings: [1.4], [1.1].
Boot OS/2 for DRAM > 64MB
This allows you to run the OS/2
®
operating system with DRAM larger than 64MB.
When you choose [Non-OS2], you cannot run the OS/2
®
operating system with
DRAM larger than 64MB. But it is possible if you choose [OS2].
Option Description
[Setup] The password prompt appears only when end users try to run
Setup.
[System] A password prompt appears every time when the computer is
powered on or when end users try to run Setup.
To Next Page
Loading...
