3-24
MS-7030 ATX Mainboard
Cell Menu
The items in Cell Menu includes some important settings of CPU, AGP, DRAM and
overclocking functions.
Current CPU / DDR Clock
These two items show the current clocks of CPU & DDR. Read-only.
DRAM Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
Max Memclock (Mhz)
User can place an artificial memory clock limit on the system. Please note that memory
is prevented from running faster than this frequency. Setting options: [Auto], [100],
[133], [166], [200].
1T/2T Memory Timing
This setting controls the SDRAM command rate. Selecting [1T] allows SDRAM
signal controller to run at 1T (T=clock cycles) rate. Selecting [2T] makes SDRAM
signal controller run at 2T rate. 1T is faster than 2T. Setting options: [1T], [2T], [Auto].
CAS# Latency (Tcl)
This controls the CAS latency, which determines the timing delay (in clock cycles)
before SDRAM starts a read command after receiving it. Settings: [Auto], [2.0], [2.5],
[3.0]. [2.0] increases the system performance the most while [3.0] provides the most
stable performance.
MSI Reminds You...
Change these settings only if you are familiar with the chipset.
To Next Page
Loading...
