JSLOW1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
Normal
(default)
Enabled
(Please enable this jumper
during BIOS POST.)
Important
y
Users will try extreme low temperature overclocking at their own risks. The
overclocking results will vary according to the CPU version.
y
Please don’t switch to Enabled when power-off or the system will be un-bootable.
Important
y
To ensure system stability for Dual/ Triple/ Quad channel mode, memory modules
must be of the same type, number and density.
y
Due to chipset resource usage, the available capacity of memory will be a little less
than the amount of installed.
y
The Memory DIMM voltage below 1.35V is suggested to protect the CPU.
y
Please note that the maximum capacity of addressable memory is 4GB or less
for 32-bit Windows OS due to the memory address limitation. Therefore, we
recommended that you to install 64-bit Windows OS if you want to install more than
4GB memory on the motherboard.
y
It is recommended to use a more efficient memory cooling system for full DIMMs
installation or overclocking.
y
The stability and compatibility of installed memory modules depend on installed CPU
and devices when overclocking.
* For 2990WX processor, DIMMC1, C2,
D1 and D2 are controlled by Die1 and
DIMMA1, A2, B1, B2 are controlled by
Die0.
To Next Page
Loading...
