50
Pin Signal Name Pin Signal Name
1 Ground 2 WFLOW PWR
3 WFLOW IN
W_FLOW1: Water Flow Meter Connector
This connector allows you to connect a water flow meter to monitor the flow rate of
your liquid cooling system.
1
Enabled
(Please enable this jumper
during BIOS POST)
Normal
(Default)
⚠
Important
∙
Please note that overclocking at an extremely low temperature carries the risk of
system instability and may cause damages to the system.
∙
The overclocking results may vary depending on the CPU you use.
∙
Do not enable the jumper when the system is power off. Otherwise, the system will
be unbootable.
JLN1: Low Temperature Booting Jumper
This jumper allows liquid nitrogen cooling system to boot at an extremely low
temperature. Please try to enable the jumper to help the system boot successfully.
To Next Page
Loading...
