51
Normal
(default)
Boot with the saved
BIOS settings.
Enabled
Apply the BIOS default
settings and lower PCIe
(from CPU) mode for
Safe Boot
JOC_FS1: Safe Boot Jumper
This jumper is used for Safe Boot. When this jumper is enabled, the system will boot
with default settings and lower PCIe (from CPU) mode.
V-Check Points Lite
These voltage checkpoints are used to measure the current system voltages. A
multimeter (not included) will be required to check voltages. To measure voltage,
place test leads on the GND (or screw mounting hole) and a specific V-Check Point.
Please refer to the manual of your multimeter for more information.
DDR1: CPU VDDIO voltage
SOC1: SOC voltage
CORE1: Core voltage
GND: Ground
To Next Page
Loading...
