34
Overview of Components
W_FLOW1: Water Flow Meter Connector
This connector allows you to connect a flow meter to monitor the flow rate of your
liquid cooling system.
1
1 Ground 3 WFLOW IN
2 WFLOW PWR (2A)
JSLOW1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
JLN1~2: Low Temperature Booting Jumper
This jumper is used for liquid nitrogen cooling system to boot at an extreme low
temperature. Try to set it Enabled to increase the boot success rate.
Normal
Enabled
Important
Users will try extreme low temperature overclocking at their own risks. The
Please don’t set to Enabled when power-off or the system will be un-bootable.
Enabled
Normal
JLN1
JLN2
JSLOW1
To Next Page
Loading...
