6-8
MS-6728 ATX Mainboard
Select the speaker by clicking it to test its functionality. The one you select will
light up and make testing sound. If any speaker fails to make sound, then check
whether the cable is inserted firmly to the connector or replace the bad speakers
with good ones. Or you may click the “Auto Test” button to test the sounds of each
speaker automatically.
3. While you are testing the speakers in 8-Channel / 6-Channel Mode, if the
sound coming from the center speaker and subwoofer is swapped, you
should select Swap Center/Subwoofer Output to re-adjust these two
channels.
Subwoofer
Front Right
Rear Right
Center
Front Left
Rear Left
Side Left Side Right
To Next Page
Loading...
