3-7
BIOS Setup
Important
IDE Channel 0/1/2/3 Master/ Slave are appearing when you connect the
HD devices to the SATA connector on the mainboard.
Drive A
This item allows you to set the type of floppy drives installed.
Halt On
The setting determines whether the system will stop if an error is detected at boot.
Available options are:
[No Errors] The system doesn’t stop for any detected error.
[All, But Keyboard] The system doesn’t stop for a keyboard error.
System Information
Press <Enter> to enter the sub-menu.
This sub-menu shows the CPU information, BIOS version and memory status of your
system (read only).
To Next Page
Loading...
