2-15
Hardware Setup
Chassis Intrusion Connector: JCI1
This connector connects to the chassis intrusion switch cable. If the chassis is
opened, the chassis intrusion mechanism will be activated. The system will record
this status and show a warning message on the screen. To clear the warning, you
must enter the BIOS utility and clear the record.
JCI1
2
CINTRU
GND
1
S/PDIF-Out Connector: JSPD1 (2pin, 3pin optional)
This connector is used to connect S/PDIF (Sony & Philips Digital Interconnect Format)
interface for digital audio transmission.
SPDIFO GND VCC
SPDIF
GND
JSPD1 (2pin, for HDMI
graphics card)
JSPD1 (3pin)
CD-In Connector: JCD1
This connector is provided for external audio input.
JCD1
GND
R
L
7346v1.0-2-Hardware.p65 2007/3/6, 上午 11:5815
To Next Page
Loading...
