En-13
English
ATX 12V Power Connector (2x2-Pin): JPWR2
This 12V power connector is used to provide power to the CPU.
1
34
2
GND
12V
GND
12V
TPM Module Connector: JTPM1 (optional)
This connector connects to a TPM (Trusted Platform Module) module (optional). Please
refer to the TPM security platform manual for more details and usages.
2
1
14
13
3Vdual / 3V_STB LCLK
LRST#
LAD0
LAD1
LAD2
LAD3
LFRAME#
VCC3
SIRQ
VCC5
Key(no pin)
GND
GND
Hardware Overclock FSB Jumpers: JB1, JB2 (optional)
You can overclock the FSB to increase the processor frequency by changing the jumpers
JB1 and JB2. Follow the instructions below to set the FSB.
Important
1. Make sure that you power off the system before changing the jumpers.
2. Overclocking may cause instability or crash during boot, then please restore
the jumpers to default.
Default
1 3 1
3
1 3
JB1
JB2
1 3
200->266 MHz
200->333 MHz 200->400 MHz
266->400 MHz
333->400 MHz
1
JB2
JB1
1
1
3
266->333 MHz
PDF created with pdfFactory Pro trial version www.pdffactory.com
To Next Page
Loading...
Need help?
General
