AIR COMPRESSOR MANUAL
- 12 -
Filling process
1. Turn handle to connect the injector and tank
2. Open the INJECTOR by turning the DISCHARGE VALVE
3. Turn the tank valve opens
4. Start compressor by pressing switch
5. When charging is completed, the set pressure stops operation of the electric motor
6. Close the injector by turning the discharge valve
7. Turn the tank valve close
8. Turning the handle to separate the tank from the injector(CCW)
9. When Charging is completed, Drain the oil-water separator condensate remains
Open the drain valve attached to the bottom of the filter housing and the oil-water
separator
WARNING
In order to prevent freezing in winter condensate
must be removed
DISCHARGE VALVE
CONNECTION
PRESSURE GAUGE
Fig.3 INJECTOR SET
INJECTOR HANDLE
To Next Page
Loading...