4. Initial connection
4.1. LANTERN START-UP
Two forms of initial connection;
Lantern in sleep mode. In order to save the batteries discharge and reduce the power
consumption, the beacon is supplied in sleep mode. For activating the beacon, it is required to
expose the lantern solar module to the sun for recovering the normal operation mode.
Lantern with the battery disconnected. The beacon is supplied with the battery disconnected,
following safety regulations according to transport specifications. In that case the beacon must
be open to connect the battery connector to the lantern flasher as attached indications:
Removing threaded screws:
Using an allen wrench to arrange for removal
of the 6 screws securing the back of the beacon.
To Next Page
Loading...