1 32
pin holepin hole
19
3. Smooth the surface to remove any air bubbles and allow it dry for 5-10 minutes
NOTE: Glue is not included.
How to fix a leaking valve
open
close
open
close
1. Inflate your spa up to the max air pressure
2. Stick your valve wrench down inside of valve and turn clockwise
to tighten the valve back down onto the spa
1. Completely deflate your spa
2. Undo the dust cap and insert the valve wrench into the valve and twist counterclockwise to
remove the valve
A. Try to tighten the valve
B. Re-install or replace a valve
3. Check the rubber ring to make sure that it is in the correct position, tight around the valve and there
is no debris in the way
4. Be sure the pin spring is functioning properly and that there are no cracks along the edges
Rubber Ring
To Next Page
Loading...
Need help?
General
