22
SPA LOOSES AIR
PRESSURE
Air valve got loosen
Hole or split on the spa tub
Put soap water in a squirt bottle and spray
on seams. If there is a leak it will bubble.
After you find the leak, clean and dry the
leaking area, then use the repair patch
comes with your spa. Check the repair
section on P18
Fill up the tub with air, make sure the air
valves are secure, replace if necessary
CONTACT YOUR LOCAL MSPA DEALER OR SERVICE CENTER FOR ANY PRODUCT RELATED QUESTIONS OR PROBLEMS.
PROBLEM CAUSE SOLUTION
OZONATOR
FAILURE
Add water above the minimum line
Water level is below the minimum
water line
Refer to "FILTER PUMP DOES NOT WORK"
section
FILTER PUMP
DOES NOT WORK
Filter stuck by dirt or other objects Clean or replace the filter cartridge
SPA LEAKING
Spa inlet/outlet connection not
securely tight
Tighten the inlet and outlet
connection
Water leaks from the spa
pool body
Drainage valve is not closed
completely
Contact the MSpa Service Center, if spa is
still leaking
Repair the leaking hole/spilt with the repair
kit material
SPA TUB IN AN
ABNORMAL
SHAPE
Extra air pressure by strong
sunlight
Check the air pressure and release some air
if necessary.
During hot weather, it is recommended to
check if it is necessary to release some air to
avoid any possible damage to the spa pool
Water has been used too long
WATER NOT
CLEAN
Refer to the chemical manufacture's
instruction
Insufficient filtering
Dirty filter cartridge
Improper water maintenance
Clean or replace the filter cartridge in time
Increase filtration frequency
Change the water
Filter pump does not work
One-way valve blocked
Filter system failure Contact the MSpa Service Center
Contact the MSpa Service Center
To Next Page
Loading...
Need help?
General
