14
SPA SET-UP
Move the entire package to the selected site. Open the carton carefully as it can be used to store the spa
during long term storage or when not in use.
Lay out all the parts on the ground and make sure all parts are accounted for. Make sure the spa tube is
right side up. (*For missing or damaged part, contact the MSpa Service Center)
Spread the Heat Preservation Ground Mat over a cleared area. Spread out the spa liner over the ground
mat. Heat Preservation Mat prevents heat loss from the bottom of the unit.
NOTE: The heat preservation ground mat is not included for the MSpa DELIGHT package . We suggest to find
a ground mat and put it between the ground and spa tub to help prevent scratch and heat loss.
1.
2.
3.
1 2 3
this side
face down
● Alpine D-AL04/06, Soho P-SH069, Tekapo D-TE06: Spread out the square ground mat and place it to the
selected site. Make sure the buckle of cover and mat is attached when spa not in use.
Spa Inflation
4.1 Plug the spa into the grounded supply socket.
4.2 Press the RESET button on the GFCI, the screen on controller shows numbers.
4.3 Turn the inflation knob to the inflation status <ON> and long press (≥2 minutes) the bubble button on
the controller to start inflating until the yellow section of the manometer is pushed out.
4.4 Stop pressing the bubble button and turn the knob back to <OFF> .
4.
4.3 4.4
Yellow
ON
OFF
BUBBLE
To Next Page
Loading...
Need help?
General
