mspa P-MB049 - Water Filling and Filter Installation; Digital Lock Operation

15


ƔThe water level must reach the Minimum water line but not exceed the Maximum line to avoid
pump failure.
ƔNever pour water with a temperature higher than 40°C (104°F) directly into the spa.
ƔTo avoid control system failure, do not operate the spa until water reaches the Minimum
line.
Water Filling
&KHFNWKHVSDPDUNLVDWWKHVHOHFWHGDUHDDQGpoint
the drain valve toward a suitable draining area
before inflation.
)LOOWKHVSDWXEZLWKIUHVKZDWHUWRDOHYHOEHWZHHQ
Minimum and Maximum line marked on the inside
of the spa wall. Do not over fill the spa. It is recommended to fill the spa with lukewarm water for quick
heating and energy saving.
WARNING:
$IWHUZDWHUILOOLQJGRXEOHFKHFNWKHVSDSRRODLUSUHVVXUHWRPDNHVXUHWKHPDQRPHWHUSRLQWVRXWWR
the Green section.
,QVWDOOWKHILOWHUFDUWULGJH3OHDVHUHIHUWRWKHLQVWUXFWLRQRQ3
3ODFHWKHLQIODWHGDLUEODGGHUDQGWKH]LSSHUVSDFRYHURYHUWKHVSDWXE0DNHVXUHWKHVSDFRYHULV
zipped and locked by the digital lock in the accessory pack.
IMPORTANT:
Ɣ,QVSHFWWKHVSDSUHVVXUHUHJXODUO\IRUOHDNSUHPDWXUHZHDURUGHWHULRUDWLRQ
Ɣ&KHFNDQGZD[WKH]LSSHUUHJXODUO\WRPDNHLWVPRRWKIRURSHUDWLRQDQGWRDYRLGVSOLWV

7XUQRQWKH+HDWHURQWKHVSDZLUHGFRQWUROOHUUHIHUWRWKH³:LUHG&RQWUROOHU2SHUDWLRQ´VHFWLRQ
Maximum heating temperature is 40°C (104°F). Hourly heating rate is about 1.5°C-2°C (2.5°F-3.5°F)
IRUSHUVRQVDQG&&))IRUSHUVRQV
Zipper and Buckle Operation
7.1 Digital Lock Operation
The default password is “000”)ROORZWKHVWHSVEHORZWRFKDQJHWKHSDVVZRUG
Ɣ3XVKWKHEXWWRQDLQWKHGLUHFWLRQRI)LJWRXQORFNWKHGLJLWDOORFN
Ɣ6HW\RXUSUHIHUUHGSDVVZRUGLQGLJLWVE\WXUQLQJWKHQXPEHUZKHHOEVHH)LJ
Ɣ,QVHUWEDFNWKHFDEOHF7KHQHZSDVVZRUGLVVHW
7.