1.1 Safety
The operating instructions must be carefully read and followed by all persons who install, use, main-
tain and check the product.
The product can only fulfill its intended functions if it is installed, used, maintained, cared for and
checked in accordance with the instructions provided by INTEC Controls | MSR-Electronic GmbH.
1.2 Responsibility Installer and Operator
It is the responsibility of the installer and operator to ensure that all PolyGard
®
2/PolyXeta®2 equip-
ment is installed and used in compliance with all national and local codes. The device must be
checked for correct installation and functionality by a qualified person before measurement opera-
tion is started. In Germany, BGR 500 Chapter 2.33 must be applied for this purpose.
The PolyGard2 devices are tested for function by the manufacturer before delivery. During commis-
sioning, a documented functional test is also required. The installation should only be carried out by
trained installation technicians, taking into account the current safety procedures for control instal-
lations.
The required equipotential bonding connections (also e.g. secondary potential to ground) or ground-
ing measures are to be carried out according to the respective project regulations. It must be ensured
that no ground loops are created in order to avoid undesired interference in the measurement elec-
tronics.
It is necessary to follow all instructions as well as the user documentation.
1.3 Maintenance
It is recommended that PolyGard
®
2/PolyXeta
®
2 equipment be inspected on a regular basis. Perfor-
mance deviations can be corrected based on regular maintenance. Recalibration and parts replace-
ment can be performed in the field by a qualified technician using the appropriate tools.
Alternatively, the easily removable, plug-in sensor head can be returned to INTEC Controls |
MSR-Electronic GmbH for service.
Regular maintenance is to be carried out according to the instructions.
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | GA_GC06_Modbus_supplement_E, 2022-04-05 | USA 221209 | Page 4 of 12
DGC6 Modbus Supplement – UserManual
To Next Page
Loading...
Need help?
General